Network reconnaissance 1.2

When issuing the command masscan -c top100.conf 198.18.0.0/23, I get no output from this command. I have tried several times over the weekend to no avail.

I wonder if it is because of this?
Error setting kali-eth0 up:
Error setting proxy-eth0 up:
Error setting damn1-eth0 up:
Error setting proxy-eth1 up:
Error setting web1-eth0 up:
Error setting web2-eth0 up:
Error setting vpn-eth0 up:
Error setting damn2-eth0 up:
Error setting damn3-eth0 up:
containernet>

Hey there - I just tested this, but wasn’t able to replicate the issue. I would recommend re-trying the lab, paying close attention to Part 1, Step 2, as the success of Step 3 depends on the config file you create in Step 2. If you’re not getting the expected results in Step 3, it’s possible something is wrong with your config file.

Alternatively, there may have been a one-off issue with the simulated network, although I don’t think the error messages are a problem, as I get those as well. If the above doesn’t work, I would recommend closing your clabnet terminal, then opening a new one and starting over.

I can confirm the lab works.